If your Audio Radar isn’t performing as expected or you’re experiencing persistent issues, performing a factory reset on the Command Center is a simple and effective troubleshooting step. Resetting the device restores it to its original factory settings (for 6 light bars), clearing any configuration errors and ensuring the system is ready for fresh setup or further troubleshooting.

In this guide, we’ll walk you through the process to reset your Audio Radar Command Center step by step. If the issue persists after resetting, please follow our step-by-step troubleshooting guide: Audio Radar Troubleshooting Guide.  

Reset Audio Radar Command Center to Factory Settings

Step 1: Enter Standby Mode

• Tap the POWER button on the Command Center once (or multiple times) until all lights on the Command Center turn off.
• This indicates that the Command Center is in STANDBY MODE.

Step 2: Perform Factory Reset

• Press and hold the round STREAM button on the Command Center for 10 seconds.

Step 3: Power On

• The Command Center is now reset to its original factory settings and powered on, ready for further use or troubleshooting.
• If the issue persists, proceed to the next section on cable checks.